hostwines.blogg.se

1. #Zebra z4m plus test page manuals#
2. #Zebra z4m plus test page manual#
3. #Zebra z4m plus test page software#
4. #Zebra z4m plus test page password#

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To ensure compliance, this printer must be used with Shielded Communication Cables.įCC Radiation Exposure Statement (for printers with RFID encoders) The user is cautioned that any changes or modifications not expressly approved by Zebra Technologies could void the user’s authority to operate the equipment. This device must accept any interference received, including interference that may cause undesired operation. This device may not cause harmful interference, andĢ. Operation is subject to the following two conditions:ġ. Iv Compliance Information Compliance Information Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Limitation of Liability In no event shall Zebra Technologies or anyone else involved in the creation, production, or delivery of the accompanying product (including hardware and software) be liable for any damages whatsoever (including, without limitation, consequential damages including loss of business profits, business interruption, or loss of business information) arising out of the use of, the results of use of, or inability to use such product, even if Zebra Technologies has been advised of the possibility of such damages. Zebra Technologies reserves the right to correct any such errors and disclaims liability resulting therefrom.

#Zebra z4m plus test page manuals#

Liability Disclaimer Zebra Technologies takes steps to ensure that its published Engineering specifications and manuals are correct however, errors do occur. All specifications and designs are subject to change without notice. Product Improvements Continuous improvement of products is a policy of Zebra Technologies.

Such proprietary information may not be used, reproduced, or disclosed to any other parties for any other purpose without the express, written permission of Zebra Technologies.

It is intended solely for the information and use of parties operating and maintaining the equipment described herein.

#Zebra z4m plus test page manual#

Proprietary Statement This manual contains proprietary information of Brady Corporation and its subsidiaries (“Zebra Technologies”). All rights reserved worldwide.Īll other brand names, product names, or trademarks belong to their respective holders. ZebraLink and all product names and numbers are trademarks, and Zebra, the Zebra logo, ZPL, ZPL II, Element Energy Equalizer Circuit, and E 3 Circuit are registered trademarks of ZIH Corp. This product may contain ZPL ®, ZPL II ®, and ZebraLink™ programs Element Energy Equalizer ® Circuit E 3 ® and Monotype Imaging fonts. Copyright violators may be subject to civil liability.

#Zebra z4m plus test page software#

Unauthorized reproduction of this manual or the software and/or firmware in the label printer may result in imprisonment of up to one year and fines of up to $10,000 The copyrights in this manual and the software and/or firmware in the label printer described therein are owned by ZIH Corp.

#Zebra z4m plus test page password#

Remove Liner in Peel-Off with Liner Take-up Mode.Load Media in Peel-Off Mode or Liner Take-Up Mode.